Sanus Systems WMS2 Instrucciones De Ensamblaje página 4

Step 1: Attach Wall Plate
The Wall Plate (a) must be mounted to a wood stud. Make sure the Wall Plate is oriented so that the flat side is against the wall and
the two tabs are closer to the bottom. Use the Wall Plate as a template to mark the 4 hole locations for the Lag Bolts (g) between the two
edges of the chosen stud. Pre-drill four holes 2.5" (6.4 cm) deep at the marked locations using a 3/16" (0.5 cm) drill bit. Attach the Wall
Plate to the wall using all four of the Lag Bolts. Tighten each Lag Bolt with the appropriate socket head. See Diagram 1 for assistance.
WARNING: Tighten Lag Bolts only until the Wall Plate is pulled firmly against the wall. DO NOT OVER-TIGHTEN
THE LAG BOLTS!
Step 2: Install Pivot
Insert a Pivot Bolt (j) down through the top tab in the Wall Plate (a), the Pivot (c), the lower tab in the Wall Plate, and finally thread it
into the Pivot Nut (k). Firmly tighten the Pivot Nut with the appropriate socket. See Diagram 2 for assistance.
c
Diagram 1
a
g
Diagram 2
j
k
a