Sanus Systems WMS2 Instrucciones De Ensamblaje página 5

Step 3: Install Arm
Insert the Arm (f) into the Pivot (c) so the hole in the Arm aligns with the hole in the Pivot. Tighten one Acorn Nut (i) onto the Threaded
Stud (h). Insert the Threaded Stud through the holes in the Pivot and Arm. Attach the other Acorn Nut on the Threaded Stud. Firmly
tighten each Acorn Nut with the appropriate socket. Thread a Long Set Screw (l) through the hole in the top and bottom of the Pivot.
The Long Set Screws control the tilt of the Arm. Tighten with Allen Key (o) until the Arm has desired tilt angle. See Diagram 3 for
assistance.
f
Step 4: Add Cover
Slide the Cover (b) so it clips onto the Wall Plate (a). See Diagram 4 for assistance.
b
Diagram 3
l
i
l
Diagram 4
c
h
i
a