Tabla de contenido
Publicidad
Preparing the mecablitz for use
Preparazione del mecablitz
Preparación del mecablitz
2. Preparing the mecablitz for use
2.1 Mounting the mecablitz
2.1.1 Mounting the mecablitz on the camera
Turn off the camera and the mecablitz by
their main switch!!
• Turn the knurled nut against the mecablitz hou-
sing until the stop point is reached. The locking
pin in the adapter shoe is now fully retracted
into the case.
• Slide the mecablitz foot completely into the
camera's accessory shoe.
• Turn the knurled nut against the camera body as
far as possible, thereby clamping the meca-
blitz.If the camera does not have a locking hole
the spring-loaded locking pin retracts into the
adapter case so that it does not damage the
surface.
2.1.2 Removing the mecablitz from the
camera
Turn off the camera and the mecablitz by
their main switch!!
• Turn the knurled nut against the mecablitz hou-
sing until the stop point is reached.
• Withdraw the mecablitz from the camera's
accessory shoe.
2.2 Power supply
2.2.1 Suitable batteries
The mecablitz can be operated with any of the
following batteries:
* 4 NiCad batteries, type IEC KR 15/51 (KR6,
size AA). They permit very fast recycling and
are economical in use because they are rechar-
geable.
* 4 nickel-metal-hydride batteries, type IEC HR6
(size AA). They have a significantly higher
capacity than NiCad batteries and are less
harmful to the environment (no cadmium).
* 4 alkaline-manganese dry-cell batteries, type
IEC LR6 (size AA/AM3). Maintenance-free
power source for moderate power requirements.
* 4 lithium batteries, type IEC FR6 L91 (size AA).
Maintenance-free high-capacity power source
with a low self-discharge rate.
12
Publicidad
Tabla de contenido
