Replacing Batteries; Changing Batteries - BRAND Titrette Instrucciones De Manejo

Replacing the batteries
A blinking battery symbol will show on the display if the battery
capacity is depleted. The batteries should then be replaced.
Use only the specified battery type: 1.5 V (AAA/UM4/LR03)
micro-battery. Batteries are not rechargeable.
1.
Unscrew the air vent cap by hand or use a coin (Fig. 1).
2.
Remove the rear housing (Fig. 2).
3.
Remove the battery case cover (Fig. 3).
4.
Remove the spent batteries using a screwdriver (Fig. 4).
5.
Insert the new batteries and press them firmly into the holders.
Observe the correct polarity of the batteries (Fig. 4).
6.
Close the battery compartment tightly with the new covers.
Carefully press the edges so that the entire cover rests firmly and
lwithout a gap between it and to the battery case.
7.
Connect the housing at the top, then snap it closed and screw in
the air vent cap.
Note:
Always exchange the battery case cover with the batteries. These are
contained in the scope of delivery for replacement batteries.
Warning!
Dispose of batteries only when completely discharged, and accord-
ing to applicable regulations. Do not short-circuit the batteries to
discharge them – this is an explosion hazard!

Replacing Batteries

1
2
3
4
61