Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
- Blinking = Drivo II is awaiting connection.
- On = Drivo II is transmitting data via the ANT+™
protocol.
Blue = Drivo II is connected via the Bluetooth Smart
protocol.
- Blinking = Drivo II is awaiting connection.
- On = Drivo II is transmitting data via the Bluetooth Smart
protocol.
10_HEART RATE MONITOR
Drivo II does not feature an integrated heart rate monitor
receiver; heart rate value is sent to the heart rate monitor
via the device connected to Drivo II.
When using the My E-Training app, confirm that ANT+™
or Bluetooth Smart smartphone protocols are compatible
with the smartphone.
11_POWER SENSOR CALIBRATION
Drivo II can calibrate the internal power measurement
system, which clears the system settings in order to
always obtain accurate power values.
The process is very simple, just select any type of training
on the home trainer and train for at least 10 minutes, then
perform the appropriate function on the My E-Training
software.
The calibration command in the mobile version can be
found in Parameters – Advanced Configuration – Home
trainer calibration, while in the desktop version it can be
found in Settings – Home trainer calibration.
This is accomplished by pedalling and increasing speed
until you reach a certain indicated value.
Remember to stop pedalling at the system prompt.
After a few seconds the system will indicate that the
calibration process was successful.
This value is then stored in the Drivo II's memory, and
accurate power data will be received from every connected
device, including non-Elite third party software / app /
devices.
Please note: the aforementioned calibration procedure can
be conducted with software / app / devices other than the
Elite ones.
12_CADENCE SENSOR
The Drivo II uses an innovative "sensorless" system that
utilizes a sophisticated calculation based on speed to track
pedal cadence.
When maintaining a high pedal cadence at low resistance
levels, there may occasionally be a slight inaccuracy
in the cadence value since it is the result of calculation
and not direct monitoring. This occurs especially with fast
pedalling and low resistance.
If the precision of the "sensorless" system is not sufficient,
it is possible to utilize the included wired sensor.
For installation on the bike, follow the instructions on the
enclosed manual.
To activate the cadence detection via the sensor,
connect the sensor to the Drivo II before starting up the
hometrainer. Some software allows the use of wireless
sensors connected directly to the app/software/device. In
this case, please consult the specifications of the software
/ app / device to verify its compatibility with wireless
cadence sensors.
13_COPYRIGHT
No part of this manual may be reproduced or transmitted
without the written authorization of Elite S.r.l.
The Elite Drivo II software and relative code are property
of Elite S.r.l.
International copyright law protects the software.
The Elite Drivo II software must be treated like any other
copyrighted material, such as books.
Users undertake not to modify or adapt the programme.
Users also undertake not to decompile, disassemble or
attempt in any way to discover the native software code.
14_NOTE
- Elite cannot be held responsible for any malfunction
involving third party software / app / device.
- The presence of high-voltage electric lines, traffic lights,
electric railway lines, bus or tram electric lines, television
sets, automobiles, cycle computers, gym equipment and
mobile phones inside the operating range of the console,
etc., can be the cause of interference. Therefore the use
of other wireless receivers may alter or completely inhibit
operation of the Drivo II due to such interference.
Do not expose the Drivo II to direct sunlight for long periods
when they are not in use.
15_DISCLAIMER
Elite S.r.l. is not liable for any temporary or permanent
damage to the physical integrity of the user, whether direct
or indirect, resulting from the use of the trainer.
EN
41
Publicidad
Tabla de contenido
