En - Installation Instructions - Kermi IDN10 Instrucciones De Empleo

EN – Instructions for use
Permissible use
The radiator may only be used for heating in-
terior spaces and drying textiles and thermally
stable materials.
Any other use is contrary to the intended pur-
pose and therefore not permissible.
Misuse
The radiator is not usable as a seating accom-
modation, climbing or lifting support.
Safety instructions
WARNING
Risk of burns!
The radiator's surface can heat up to 110 °C
(230 °F).
Be careful when touching the radiator.
►
CAUTION
Risk of burns due to squirting hot water
when evacuating air!
Protect your face and hands.
►
Electrical accessory operation (IDN11)
Do not operate the radiator with a dam-
►
aged connection cable.
Make sure that the return is open. Heating
►
increases the water's volume.
Close the thermostatic head.
►
Maintenance
Vent the radiator after commissioning and
►
following lengthy interruptions of opera-
tion.
Cleaning
Use only mild, non-abrasive cleansing
►
agents.
Complaint
► Contact your local dealer.
Installation and repairs
Have the installation and repairs performed
►
by a specialized tradesman so that your
claims under warranty are not forfeited.
Disposal
Recycle or dispose of disused radiators, in-
►
cluding accessories, properly. Observe local
regulations.
EN – Installation instructions
The radiator may only be installed by a special-
ized tradesman.
For electrical accessory operation (IDN11) the
following activities may only be performed
by an electrically qualified person pursuant to
BGV A3:
•
Installation and connection of the electric
set
•
Connection of the heating element to the
electric set
Safety instructions
Read these instructions thoroughly prior to
►
installation.
After installation pass the instructions on
►
to the end user.
Observe the safety directions in the sepa-
►
rate electric set instructions.
DANGER
Life-threatening situation!
Check the condition of the supply lines
►
(electricity, gas, water).
Do not drill into any lines.
►
WARNING
Risk of injury!
Take the radiator's weight into account
►
(see page 37).
► At 25 kg and above, work with lifting
equipment or several persons.
WARNING
Personal injury and material damage!
Check the base for adequate carrying ca-
►
pacity. Take the weight of the filled radi-
ator (see page37) and possible additional
loads into account.
Check fasteners for applicability and tai-
►
lor them to the structural situation.
Special requirements, e.g. for public
►
buildings (schools or the like), must be
taken into account.
5