Calibrating The Pedals - Korg sv2 vs Guia De Inicio Rapido

Calibrating the pedals

You can calibrate the pedals connected to the DAMPER, PEDAL 1 and PEDAL
2 connectors in the back panel. By calibrating a pedal, you let the SV­2 un­
derstand its polarity and the full range of values sent.
1 Connect all pedals to be calibrated to the SV­2. Remember that DAMPER
expects the included KORG DS­2H damper pedal (or, as an alternative, the
optional DS­1H, or any footswitch pedal), PEDAL 1 expects a footswitch ped­
al, and PEDAL 2 can be used to connect either a footswitch or a volume/
expression pedal.
2 Set any volume/expression­type pedal to its lowest setting.
3 Turn the SV­2 off.
4 Keep the Auto/Pedal button pressed, and turn the SV­2 on.
5 When the Auto/Pedal LED starts to flash, release the button.
If you do nothing in the next few seconds, the Auto/Pedal LED will turn off,
and the SV­2 will complete the start­up sequence.
6 While the Auto/Pedal LED is flashing, press the button again. SV­2 enters
calibration mode.
7 Now calibrate PEDAL 1 (a footswitch). Completely depress the pedal, then
release it. When you have finished calibrating the pedal connected to the
PEDAL 1 jack, FAVORITES button #1 will turn on.
8 Then, calibrate PEDAL 2. The procedure is different, depending on the use
of a footswitch or a volume/expression pedal:
▪
If you connected a footswitch, completely depress it, then release it.
▪
If you connected a volume/expression pedal, push it all the way forward to
its maximum position.
When you have finished calibrating the pedal connected to the PEDAL 2
jack, FAVORITES button #2 will turn on.
9 Finally calibrate the DAMPER pedal. Completely depress the pedal, then
release it. When you have finished calibrating the pedal connected to the
DAMPER jack, FAVORITES button #3 will turn on.
10 When finished calibrating:
▪
If you calibrated all three pedals connected, SV­2 automatically exits calibra­
tion mode and continue the start­up sequence.
▪
If you calibrated only one or two pedals, press the Auto/Pedal button again
to exit calibration mode and continue the start­up sequence.
Advanced settings |27