Preparation For Operation; Operation And Maintenance - GRAPHITE 59G335 Manual Del Usuario

INSTALLATION OF SANDING PAPER
The sander is equipped with pad with so called hook-and-loop, only appropriate sanding paper should be
used.
●
Put the sanding paper close to the backing pad (
●
Place the sanding paper so it's holes (
●
Press the paper against the backing pad (
●
Ensure that the holes on the sanding paper and backing pad fully match; it ensures possibility of dust
extraction.
Sanding paper must thoroughly adhere to the sander backing pad.
DUST EXTRACTION
Use perforated sanding paper, so the dust can reach the dust extraction outlet (2) through the backing pad
(3). You can also use external dust extraction system by connecting it to the adaptor (4).
SWITCHING ON / SWITCHING OFF
The mains voltage must match the voltage on the rating plate of the sander.
●
Switching on – press the switch button (1) to position I (fig. B)..
●
Switching off – press the switch button (1) to position O.
WORKING WITH DELTA SANDER
●Whole sanding area must rest on the processed surface.
●
Turn the sander on, apply moderate pressure and move it on the processed material.
●
When finishing to sand, reduce pressure, lift the sander and only after that switch the tool off.
Disconnect the tool from power supply network before starting any adjustment, maintenance or
repair.
●
Soft brush or stream of compressed air are best for cleaning the sander.
●
Do not clean with water or cemical cleaning agents.
●
Clean the sander on a regular basis, preferably after each work.
●
Always keep the sander and ventilation holes clean.
●
Always store the sander in a dry place, beyond reach of children.
●
In case of excessive commutator sparking have the technical condition of carbon brushes of the motor
checked by a qualified person.
REPLACEMENT OF BACKING PAD
Damaged backing pad (3) must be replaced immediately.
●
Unscrew the screws that fix the backing pad (
●
Remove and replace the backing pad.
●
Tighten the fixing screws.
REPLACEMENT OF CARBON BRUSHES
Replace immediately worn out (shorter than 5 mm), burnt or cracked motor carbon brushes. Always
replace both brushes at a time.
Entrust replacement of carbon brushes only to a qualified person. Only original parts should be
used.
All faults should be repaired by service workshop authorized by the manufacturer.

PREPARATION FOR OPERATION

3).
a) match holes on the sander backing pad.
3) (fig. A).
OPERATION / SETTINGS

OPERATION AND MAINTENANCE

3).
9