Brief Description Of The Modes - Berner 186414 Instrucciones De Uso

5. Brief description of the modes

*
iMportANt:
to get from one mode to the next, hold down the button (8) until you receive
acoustic confirmation.
Mode 1:
Main mode
As soon as the Power Probe is
connected to a voltage source,
Sound on it is in main mode and the
signal tone is on (
Briefly switching on the button
switches the signal tone off.
When making contact with
a positive circuit, the LCD is
illuminated in red. Upon contact
Sound off
with a negative circuit, it is
illuminated in green.
The measured voltage is shown
in the display.
Mode 2:
Voltage minimum
Shows the lowest voltage.
Press on the button briefly to
The LCD shows
delete the message on the
a minus ( )
display for a new measurement.
Mode 3:
Voltage maximum
Shows the highest voltage.
Press on the button briefly to
The LCD shows
delete the message on the
a plus ( )
display for a new measurement.
The LCD shows
a P ( )
).
The LCD
switches
between the
minus and plus
( /
LCD display with
triggered fuse
Mode 4:
Peak-to-peak measurement
Shows the differential between
the highest and lowest voltage.
Mode 5:
Threshold value setting for the
voltage measurement
Shows the specified threshold
voltage for the voltage
measurement.
Briefly press on the button to
increase the displayed value.
)
When you have reached the
desired value, press the button
until you hear a beep.
The display returns to main
mode, the value is saved.
Fuse triggered:
Is displayed by two zeros on
the display, red blinking LCD
and an interval-shaped warning
tone.
11