Electromagnetic Compatibility - Stryker SYSTEM G 7305-001-000 Instrucciones De Uso

7305-001-700 Rev-A

Electromagnetic Compatibility

The STRYKER SYSTEM G Rotary Drill (REF 7305-001-000) is intended for use in the electromagnetic environment specified below. The customer or the
user of the STRYKER SYSTEM G Rotary Drill (REF 7305-001-000) should assure that it is used in such an environment.
Emissions test Compliance
RF emissions Group 1
CISPR 11
RF emissions Class B
CISPR 11
Harmonic
emissions
IEC 61000-3-2
Voltage
fluctuations/flicker
emissions
IEC 61000-3-3
The STRYKER SYSTEM G Rotary Drill (REF 7305-001-000) is intended for use in the electromagnetic environment specified below. The customer or the
user of the STRYKER SYSTEM G Rotary Drill (REF 7305-001-000) should assure that it is used in such an environment.
Immunity test
Electrostatic discharge (ESD)
IEC 61000-4-2
Electrical fast transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short interruptions and
voltage variations on power supply
input lines
IEC 61000-4-11
Power frequency (50/
60 Hz) magnetic field
IEC 61000-4-8
NOTE: U is the alternating current mains voltage prior to application of the test level.
T
www.stryker.com
Guidance and manufacturer's declaration - electromagnetic emissions
The STRYKER SYSTEM G Rotary Drill (REF 7305-001-000) uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to cause any interference in nearby electronic
The STRYKER SYSTEM G Rotary Drill (REF 7305-001-000) is suitable for use in all establishments, including
domestic establishments and those directly connected to the public low-voltage power supply network that
N/A
N/A
Guidance and manufacturer's declaration - electromagnetic immunity
IEC 60601 test level
±6 kV contact
±8 kV air
±2 kV for power supply lines
±1 kV for input/output lines
±1 kV line(s) to line(s)
±2 kV line(s) to earth
<5% U (>95% dip in U
T
for 0,5 cycle
40% U (60% dip in U
T
for 5 cycles
70% U (30% dip in U
T
for 25 cycles
<5% U (>95% dip in U
T
for 5 seconds
3 A/m
Electromagnetic environment - guidance
equipment.
supplies buildings used for domestic purposes.
Compliance level
±6 kV contact
±8 kV air
N/A
N/A
N/A
N/A
) N/A
T
) N/A
T
) N/A
T
) N/A
T
3 A/m
Electromagnetic environment -
guidance
Floors should be wood, concrete or
ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30%.
N/A
N/A
N/A
Power frequency magnetic fields
should be at levels characteristics
of a typical location in a typical
commercial or hospital environment.
EN
17