diversey Taski swingo 2100µicro Traducción De Las Instrucciones Originales De Uso página 10

Adjust steering wheel
• Unlock the lever [1], adjust the steer-
ing wheel [2] to the desired position,
and lock the lever again.
2
1
Relocation drive
The driving direction can be controlled with the steering wheel and the
speed with the gas pedal. The speed is continuously regulated.
When the gas pedal is released, the machine decelerates until it stops
and the parking brake is activated.
Driving forward
• Switch on the machine (key switch).
• All indicator elements light up briefly.
The battery level indicator notifies
you that the machine is ready for op-
eration.
(in case of malfunction, see page
16).
• To drive forward, you only need to press the gas pedal.
Caution:
The speed is electronically reduced for driving
around corners.
Reversing
• When the reversing button is activat-
ed, the indicator below lights up and
an acoustic signal is emitted.
Moving the machine (in case of defect)
Notice:
Generally, the machine should only be moved in
pairs.
Warning:
Due to its heavy weight, moving the machine man-
ually is very risky!
Missteps can lead to personal injury and damage to the
machine.
• It can only be moved once the release button/lever is acti-
vated. (See page 7)
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Caution:
Do not use brushes which have reached their wear
limit. The wear limit is indicated by the length of the
red bristle. Do not use worn or contaminated pads.
Use original TASKI brushes only.
Failure to observe these instructions may result in inad-
equate cleaning results or even floor damage.
• Position the tools under the brush unit.
• Press the Brush drive ON/OFF but-
ton.
The brush unit will be lowered auto-
matically; the tools will be engaged
and stopped.
Caution:
Check whether the brushes are engaged.
Notice:
The brush drive is activated by pressing the gas
pedal.
Suction nozzle assembly
• The machine must be switched off.
• Position the squeegee (2) below the
1
squeegee holder (1).
2
1
2
• Push the squeegee upwards to latch
the squeegee holder.
• Press the position locks together and
insert the suction hose into the desig-
nated opening.
9