Troubleshooting - Amibot Prime Manual Del Usuario

Troubleshooting

Voice demonstration for troubleshooting
1. Please install the dust bin.
2. Please clean the suction inlet.
3. Please turn on the power switch.
4. Front bumper switch fault. (Check sensitivity of front bumper or there is a loose front bumper
bottom screw).
5. Side brush fault (Check if any obstacle wired on side brush.)
6. Wheel overload (Check if any obstacle wired on side brush.)
7. Please put the machine in a safe place.
Note:
Please solve the issue according to the voice demonstration. If all the solutions given above don't
work for you, please take actions below:
a. Re-start the robot by turning off the power switch and then turn it on.
b. If it is still not working, please send the robot to seller for repairing and maintenance.
15