Safety; Intended Use; Important Safety Instructions - SMA PPM-RC-10 Instrucciones De Funcionamiento

SMA Solar Technology AG

2 Safety

2.1

Intended Use

The Redundancy Connector serves to connect digital inputs and outputs to 2 redundant Power Plant Managers. The
Redundancy Connector transmits the specifications of the digital inputs to the 2 redundant Power Plant Managers, but
only transfers the adjusting commands of the active Power Plant Manager to the digital outputs. This ensures that the
state of the digital outputs is only determined by the active Power Plant Manager and is independent of the state of the
redundant Power Plant Manager.
The product must only be used with device type PPM-10 (Power Plant Manager).
The product is for use in weather-protected outdoor areas and in indoor areas. The ambient conditions prescribed for
the product must be observed at all times.
The product is intended for use in industrial environments.
All components must remain within their permitted operating ranges and their installation requirements at all times.
Use SMA products only in accordance with the information provided in the enclosed documentation and with the
locally applicable laws, regulations, standards and directives. Any other application may cause personal injury or
property damage.
Alterations to the SMA products, e.g., changes or modifications, are only permitted with the express written permission
of SMA Solar Technology AG. Unauthorized alterations will void guarantee and warranty claims and in most cases
terminate the operating license. SMA Solar Technology AG shall not be held liable for any damage caused by such
changes.
Any use of the product other than that described in the Intended Use section does not qualify as the intended use.
The enclosed documentation is an integral part of this product. Keep the documentation in a convenient, dry place for
future reference and observe all instructions contained therein.
This document does not replace and is not intended to replace any local, state, provincial, federal or national laws,
regulations or codes applicable to the installation, electrical safety and use of the product. SMA Solar Technology AG
assumes no responsibility for the compliance or non-compliance with such laws or codes in connection with the
installation of the product.
The type label must remain permanently attached to the product.
2.2

IMPORTANT SAFETY INSTRUCTIONS

Keep the manual for future reference.
This section contains safety information that must be observed at all times when working.
The product has been designed and tested in accordance with international safety requirements. As with all electrical
or electronical devices, there are residual risks despite careful construction. To prevent personal injury and property
damage and to ensure long-term operation of the product, read this section carefully and observe all safety
information at all times.
Operating manual
2 Safety
PPM-RC-10-BE-xx-10 7