First Use - Kalorik USK FT 1 Manual De Instrucciones

Remove the control panel from the appliance. To do this, gently
•
pull the control panel upwards until it is released.
Take the interior bowl with your two hands and pull it up gently.
•
ASSEMBLING THE DEEP FAT FRYER
Stand the appliance on a dry horizontal surface.
•
Place the bowl back in the housing and push it downwards.
•
Replace the control panel and the accessories. To replace the
•
control panel, firmly slide the control panel downward into the
location grooves on the back of the housing until it is locked.
NOTE: The appliance will only operate when the control panel is
•
correctly fitted to the outer jacket.
Unfold the handle of the basket until it is locked to allow rising the
•
basket easily.
Put the remaining power cord length in the cord storage in the
•
back of the appliance.

FIRST USE

When using the appliance for the first time, pour the required
•
amount of oil in the bowl, making sure that the level is between
the MIN and MAX marks indicated inside the bowl.
We recommend that you use a liquid oil that is suitable for deep
•
fat frying. Check the label on the bottle. If you wish to use a solid
fat, cut the fat in small pieces. Plug in the appliance, put the
thermostat on the minimum position and add the fat pieces
slowly. When the fat has melted, set the thermostat to the desired
temperature. Warning: failure to observe this will damage your
deep fat fryer.
USE
Plug in the appliance and set the thermostat to the desired
•
temperature. The power light (3) and the pilot light (4) will
illuminate. As soon as the desired temperature is reached, the
pilot light (4) will go out. When the temperature falls, the
thermostat will be activated again, and the pilot light will
5
USK FT 1 - 060620