Maintenance Position - Riello BG1 Instrucciones De Instalación, Uso Y Mantenimiento

4.4

MAINTENANCE POSITION

THE ACCESSIBILITY TO THE NOZZLE, THE DIFFUSER DISC AND THE ELECTRODES IS MADE
EASY IN 2 WAYS:
Remove the burner out of the boiler, after loosing
the fixing nut to the flange.
Hook the burner to the flange (1), by removing the
flame tube (2) after loosing the fixing screws (3).
Remove the small cables (4) from the electrodes
and the diffuser disc-holder assembly (5) from
the nozzle-holder assembly after loosing its fixing
screw (3, fig. 11-12, page 7).
Screw the nozzle (6) correctly and tighten it as
shown in the figure.
5
4
Fig. 13
ATTENTION
During the reassembly of the nozzle-holder assembly screw the nut (3) as shown in fig. 15.
In order to guarantee the sealing of the fan in its seat, make sure that there is at least 1 mm of spring tension
between nozzle-holder assembly and casing. Therefore the fixing split pin (11) will have to be extended at
least of 1 mm beyond the flange of the nozzle-holder assembly.
TIGHTEN WITHOUT MOVING
BACKWARDS TO THE END
3399
2
6 1
3
D8220
9
D5684
Remove nozzle-holder assembly (1) after loosing
screws (2) and nut (3), remove the small cables
(6) from the control box, the socket (4) and the
flame detector (5).
Withdraw the small cables (6) from the electro-
des, remove the diffuser disc-holder assembly (9)
from the nozzle-holder assembly (1) after loosing
screw (3, fig. 11-12, page 7).
Screw the nozzle (10) correctly and tighten it as
shown in figure.
D8217
Fig. 15
8 GB
Fig. 14