Clamping The Wheel - ATH M126 Manual Del Usuario

Clamping the wheel

In principle, the guidelines of the German Rubber Industry Trade Association
(Wirtschaftsverband der deutschen Kautschukindustrie) should be observed when
removing tyres.
Handling heavy loads:
- Loads up to 35 kg may be handled by one person, no special handling aids are required
(see also EN 1005);
- Loads between 35 and 70 kg should be handled by two persons (also check the spatial
requirements and instructions) or using the transport / lifting aids provided;
- Loads over 70 kg require a handling or lifting system.
There are different types of truck rims (Fig. 8
Use the four clamping jaws to select the appropriate clamp for the rim.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
WARNING!
Note that the most secure tension is always at the inner hole.
WARNING!
Never leave the work area while the wheel is still raised or tensioned.
WARNING!
When tightening the rim, make sure that the clamping jaws are correctly
positioned on the rim to prevent the wheel from falling down.
E/1-E6).
Manufacturer ATH-Heinl GmbH & CO.KG
- 8 -