Inflating The Tyre - ATH M126 Manual Del Usuario

Inflating the tyre

The maximum tyre pressure may not exceed 3.5 bar.
All parts of the body should be kept away from the tyre.
During operation the noise level can reach 85 dB (A), so the operator should take
appropriate protective measures.
A tyre explosion under pressure can be very dangerous. A tyre explosion can cause
serious injury to the operator and may even be fatal.
Inflate the tyre only after placing the wheel in an approved inflation chamber.
Do not stand in the vicinity of the wheel or cage during inflation.
Do not exceed the maximum inflation pressure recommended by the manufacturer.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
Ensure that the tyre has been fully lubricated.
Start the inflation process.
If the air volume of the tyre inflator is not sufficient to push the tyre
over the wheel rim, you can increase the air volume by removing
the inner valve. This must be replaced quickly afterwards.
Ensure that the tyre has been inflated to the correct pressure.
Consult the manufacturer's specifications to establish this.
If the tyre pressure is too low, this can lead to increased wear and
decrease the service life of the tyre. The inside of the tyre can also
be damaged.
The tyre pressure must be checked once a week.
Only check the tyre pressure at normal tyre temperatures (i.e. the
vehicle has not been driven for more than an hour and not more
than 2-3 km)
Manufacturer ATH-Heinl GmbH & CO.KG
- 14 -