ATH M126 Manual Del Usuario página 56

>
>
>
>
>
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
First, the tyre bead must be completely pressed off from both sides
of the rim with the bead breaker roller. During this process, the
mounting paste is applied to the rim and the tyre bead.
Start with the upper bead.
Place the bead breaker roller on the outside of the tyre. In order to
complete the assembly without any damage, the roller must be
positioned around 1 cm from the edge of the rim flange.
Operate the lever for lowering the assembly tower until the tyre is
released from the rim.
Begin the rotation process to release the entire tyre from the rim.
Operate the lever for lifting the assembly tower to release the
pressure from the tyre and allow for swivelling.
Swivel the wheel forward and lower the assembly tower until the
bead breaker roller is under the wheel. The wheel can then be
swivelled back towards the tower in order to press off the lower
bead.
Press off the lower tyre bead.
Place the bead breaker roller on the outside of the tyre. In order to
complete the assembly without any damage, the roller must be
positioned around 1 cm from the edge of the rim flange.
Operate the lever for lifting the assembly tower until the tyre is
released from the rim.
Begin the rotation process to release the entire tyre from the rim.
Then continue with the removal procedure.
Manufacturer ATH-Heinl GmbH & CO.KG
- 10 -