Ryobi RLT30CESC Manual De Utilización página 20

WARNING
If any parts are damaged or missing, do not
operate this tool until the parts are replaced.
Failure to heed this warning could result in serious
personal injury.
WARNING
Do not attempt to modify the product or create
accessories not recommended for use with the
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
WARNING
Never attach or adjust any attachment while
power head is running. Failure to stop the engine
may cause serious personal injury.
WARNING
Be certain the knob is fully tightened before
operating equipment; check it periodically for
tightness during use to avoid serious injury.
Packing list
■ Trimmer
■ Trimmer attachment shaft
■ Front handle assembly
■ Deflector
■ Reel Easy Line Trimmer Head
■ Wrench (2 types)
■ Manual
■ Figure sheet
■ Engine oil
ATTACHING THE FRONT HANDLE (Fig. 2a)
■ Remove the securing bolts and bracket from the front
handle.
■ Align the hooks into upper shaft slot.
■ Install the front handle onto the upper shaft.
Note: The front handle should tilt slightly towards the
operator when correctly fitted.
■ Place the securing bolts through the front handle and
securely tighten them into the captive nuts on the
bracket.
English(Original instructions)
ATTACHING THE DEFLECTOR (Fig. 2b)
■ Loosen the lock nut.
■ Insert the shaft into the deflector.
■ Tighten the lock nut.
ATTACHING THE POWER HEAD TO TRIMMER
ATTACHMENT (Fig. 2c)
WARNING: Never attach or adjust any attachment while
power head is running. Failure to stop the engine may
cause serious personal injury.
■ The trimmer attachment connects to the power head
■ Loosen the knob on the coupler of the power head
■ Push in the button located on the attachment shaft.
■ Align the button with the guide recess on the power
■ Rotate the attachment shaft until the button locks into
■ Tighten the knob securely.
REMOVING THE ATTACHMENT FROM THE POWER
HEAD
■ Loosen the knob.
■ Push in the button and twist the shafts to remove and
INSTALLING THE ReelEasy TM LINE TRIMMER HEAD
(Fig. 2d)
■ Remove the paper tube.
■ Open the Reel Easy Line Trimmer Head by
■ Remove the line trimmer head cover, bump knob,
■ Place the cutting head housing on the drive shaft.
■ Install the hex bolt to secure the line trimmer head
17
Note: Do not attempt to remove the hooks on the
bracket, the hooks limits the upper position of the front
handle.
by means of a coupler device.
shaft and remove the end cap from the attachment.
head coupler and slide the two shafts together.
the positioning hole.
NOTE: If the button does not release completely in
the positioning hole, the shafts are not locked into
place. Slightly rotate from side to side until the button
is locked into place.
separate the ends.
depressing the latches on each side. The contents
of the line trimmer head are spring loaded, so keep
your other hand over the line trimmer head cover while
depressing the latches.
spring, and line spool and set aside.
Make sure the housing is fully seated.
to the drive shaft. Tighten by using the hex-shaped
opening on the inside of the bump knob.