Mopar 82212166 Manual De Instrucciones página 16

16
65. Carefully slice a small hole in the rubber portion
of the grommet (2) away from the existing wiring.
66. Insert the overlay harness (1) into the new opening
and feed the remaining portion of the harness into the
floor pan opening.
67. Using weatherstrip adhesive or equivalent, seal the
area previously sliced and let dry.
68. Re­install the grommet and fold carpet back over.
69. Raise and support the vehicle.
70. Locate the overlay harness (1) in the area above the
fuel tank.
71. Route the harness (1) rearward away from any mov­
ing parts.
72. Using the kit supplied plastic convoluted tubing (1),
cover the overlay harness and slide it up above the
fuel tank until the entire overlay harness is covered.
73. Carefully cut off any excess tubing and strategically
tape the tubing to secure.
Feb 18, 2011 K6860984