Mopar 82212110 Instrucciones De Montaje página 13

52. Using a trim stick C­4755 or equivalent, separate the
retaining clips and remove the cover (1).
53. Route the radio to power source harness along knee
bolster braces and behind radio opening and zip tie to
the knee bolster braces.
54. Look inside and note position of the retaining bosses
(2).
55. Insert Remover, Power Outlet 10246 (1) into the re­
taining bosses (2) of the power outlet.
56. Pull out the base through the mounting ring by gently
rocking the tool.
57. Use the following steps to splice the backup camera
power wire (WT/LG) to the (DB/PK) of cavity 1 on the
power outlet connector.
58. Cut the DB/PK wire.
59. Remove 13 mm (0.5 in.) of insulation from each wire
that needs to be spliced.
60. Place a piece of adhesive lined heat shrink tubing (2)
on one side of the wire. Make sure the tubing will be
long enough to cover and seal the entire repair area.
61. Place the strands of wire overlapping each other in­
side of the splice clip (1).
Jun 16, 2010
13
K6860985 ver. 1