Mopar 82212110 Instrucciones De Montaje página 6

6
17. Install the camera extension harness electrical hard­
shell connector.
18. Align light bar assembly (1) with holes in liftgate and
insert into liftgate
19. With liftgate (2) in the open position, install four fas­
teners from the inside of the liftgate.
20. Tighten the fasteners to 7.5 N∙m (66 in.pds.)
21. Reconnect the wiring harnesses.
22. Using hand pressure, press firmly and evenly on the
upper trim panel (2) over each of the fastener loca­
tions until the fasteners are fully engaged in the holes
on the inside of the liftgate.
23. Install the flip glass weather­strip.
24. Check to be certain that the fasteners are properly in­
stalled and in good condition on the inside of the trim
panel.
25. Connect the lighting connector.
26. Position the top of the liftgate trim (1) onto the liftgate
and seat the upper retaining clips (2) fully.
27. Using hand pressure, press firmly and evenly on the
trim panel (1) over each of the six lower retaining clip
locations (3) until the clips are seated fully in the holes
on the inside of the liftgate.
28. Secure the trim panel (2) to the inside of the liftgate.
Jun 16, 2010 K6860985 ver. 1