11. Using a trim stick C4755 or equivalent, disengage the
retaining clips that secure the upper liftgate trim panel
to the liftgate opening and remove the trim panel.
12. If equipped, disconnect the cargo lamp electrical con
nector.
13. Route the camera extension harness (1) through the
body and liftgate connector housings.
CAUTION: When pulling the harness through the con
nector housing be careful not to damage the camera
extension harness pins.
14. Route the camera extension harness open terminal
side along the liftgate harness and zip tie.
15. Route the camera extension harness through the hole
for the latch handle.
Jun 16, 2010
3
K6860985 ver. 1