Hoonved HD 40 BT Instrucciones Para El Uso Y El Mantenimiento página 37

Part 2: For the operator
2.1.e.1Manual draining for mach. with drainage pump
For machines fitted with a drainage pump it is possible
to empty the tank by carrying out the manual draining
cycle, during which only the drainage pump remains
active.
IMPORTANT
This cycle can only be carried out by leaving the ma-
chine SWITCHED ON with the tank full of water and the
door OPEN.
Having released the overflow, press and hold the
START (S3) button until the LED
gether) begins to FLASH, and then release the
(S3) button;
The DRAINAGE CYCLE will begin.
IMPORTANT
By pressing the START (ST) button or switching the
power switch (Q1) to OFF, you can interrupt the drain-
age cycle before the preset time is up;
to restart the interrupted cycle, press
again.
LC2
When the LED lights up CONSTANTLY,
the drainage cycle is finished.
At the end of the cycle, restore the filters (19/25) and
the overflow (13) to their respective positions.
2.1.f Switching off at the end of the day
At the end of the working day SWITCH OFF the ma-
chine by pressing the power switch (Q1) into the OFF
position.
Switch off the mains switch feeding the machine and
close the water supply taps.
For any repairs, contact only assistance centres author-
ised by the manufacturer.
2.1.g Warnings during the operation
1) Ensure that the washing temperature remains at
approx. 55-60°C;
2) Avoid immersing bare hands in the detergent-filled
water; if this should happen, rinse immediately and tho-
roughly with running water;
3) Use only anti-foaming detergents, specifics for use in
industrial machines;
4) Deactivate the machine in case of break-down or
malfunction.
For any repairs, contact only assistance centres autho-
rised by the manufacturer, and insist on the use of origi-
nal parts.
5) In no case should you change the the original formu-
lations without first consulting an authorised assistance
centre;
6) When the machine is operating, do not open the door
too rapidly.
7) Wash tank water should be changed at least twice a
day or according to daily wash requirements.
Failure to follow the above warnings may compro-
mise the safety of the washing machine.
2.1.h Usefull advice for better washing results
Any unsatisfactory results from washing can be seen
when traces of dirt are left on dishes or other items; any
water marks may be caused by insufficient rinsing.
In this case, ensure that the rinsing nozzles (22) are
clean
and that there is pressure in the water system.
If there are traces of waste, ensure that:
- The filters (19) are clean;
- the water temperature is around 55-60°C;
- items are correctly positioned in the basket;
LC2 and CHECK to-
- the washing/rinsing nozzles are clean;
START
- the arms (20/21) rotate freely.
START
(S3)
ENGLISH
37