Parts Of The Microinr® Meter; Charging The Microinr® Meter; Setting The Time And Date - iLine microsystems microINR Instrucciones De Uso

2.2 PARTS OF THE microINR® METER
MINI USB CONNECTION
EXIT (E) BUTTON
2.3 CHARGING THE microINR® METER
The Meter uses a lithium battery that can be recharged
through the mini USB connection on the top of the Meter.
The recommended charging time is approximately 3 hours.
Charge the battery completely before using the Meter
for the first time.
Do not open or manipulate the Meter.
Do not pierce or burn the battery.
Do not change the battery. The manufacturer will not
warranty Meters that have been opened.
For battery replacement or meter repairs, the
equipment must be sent to the manufacturer.
MEMORY (M)
Use only the supplied charger and wall power adapter
BUTTON
provided by the manufacturer or you may damage the
Meter.

2.4 SETTING THE TIME AND DATE

DISPLAY
Before using the microINR System, check that the
Meter's time and date are correct, since those are
necessary to determine the Chips' expiration date.
Those parameters are set during the manufacturing process,
so it probably will not be necessary to change them.
Time format: 24 hours. Date format: DD-MM-YYYY.
CHIP
INSERTION
Follow the steps described below to change the Meter's time
AREA
and date. Change only the digits needed to be set and confirm
the rest digits:
• Press and hold the left and right buttons (E and M) at the
same time for 10 seconds until the time field flashes.
• Press the left button (E) to set the hour.
• After selecting the correct hour, press the right button (M) and
set the minutes.
• After selecting the minutes, press the right button (M) again
06