Installation - SURE petcare DualScan Microchip Cat Flap Manual De Uso

6. Installation

DIY installation may involve the use of power tools or cut glass. Safety equipment
(gloves, eye protection, etc.) should be used and if in doubt consult a professional to
carry out the installation.
Suitable door types
Instructions are provided for installation in all door types, including wooden, plastic, glass, and
metal. Before installing in a door with unknown construction please check for a metal
plate in case a larger hole is required, as described in the metal door installation section.
If you can only be sure of the construction of the door by drilling a hole in it, make a trial
hole anywhere covered by the proposed hole for the DualScan cat flap.
Cat Flap positioning
The ideal height of the DualScan cat flap is such that the base of the tunnel is the same height
above the ground as your cat's stomach. In practice however, mounting is normally dictated by
features in the door into which the unit will be installed. In these circumstances, it is usual to
mount the cat flap as low as possible.
Note - the interior frame of the DualScan cat flap has a depth of 70mm (2 3/4") in order to
incorporate the double antenna, this should be considered when choosing the installation
location to ensure it will not be damaged. You should ensure that the cat flap will not be hit
against the wall or other object when the door is opened.
6.1 Installation in wooden doors, plastic doors, or plasterboard walls
1. Place the external frame face down as in Figure 4. Attach a ball of Blu Tack (or similar
adhesive putty) in each of the four corners. These should allow you to stick the frame to
most doors.
2. Choose the position on the door at which you want to mount the cat flap and stick the
frame to the door. To ensure that it is level we recommend you use a spirit level as shown
in Figure 5.
3. Use a sharpened pencil or pen to mark where the inside of the frame touches the door as
well as the two screw holes. You need to make a legible line as this will be used for cutting
against.
4. Remove the frame from the door and check you have a solid line and dots where the screw
holes are, as in Figure 6. Using a drill with a 6mm (1/4") diameter bit, drill the two holes for
the screws. It is vital these holes are drilled straight to ensure the two halves of the cat
flap connect properly.
5. Before you cut out the hole for the tunnel drill holes in all the corners large enough to allow
your jigsaw blade through. Cut out the tunnel hole with an electric jigsaw – ensure you cut
3mm (1/8") outside the line you have marked for the hole to allow enough clearance for
the tunnel. Make sure that your jigsaw is sitting flat on the door at all times while cutting.
See Figure 7.
6. Clean off any loose debris, dust and dirt from the door before you install the DualScan cat
flap, see Figure 8.
Mount the cat flap in the hole with the main assembly (battery cover) inside the house.
7.
See Figure 9.
10