Trial Run - Ugin PROGRAMIX 25 Modo De Empleo

11)
INDICATORS
►Double
- Programs 0 through 19 are simple three-stage programs.
- Programs 20 through 29 are double 6-stage programs.
While programs 20 through 29 are being set up, this indicator goes off for stages 1 to 3 and on for
stages 4 to 6.
►Calibration
The "calibration" function is used to adjust the heating temperature in the furnace within a range of +
or – 50°C, by increments of 10°C (see the following page)
► Heating element
This indicator visualizes the electric pulses transmitted to the muffle.
It continues to blink during the heat rise or hold time.
►Ventilation
A flue exhauster (available as an option) may be connected via the socket located on the back panel of the
PROGRAMIX furnaces (25-50-100).
It is programmed after the final time-delay parameter has been set by pressing the
then
The exhauster starts operating at the beginning of the heating cycle and stops when the
programmed temperature is reached.

TRIAL RUN:

After installing your furnace according to the instructions, on page SPECIFICATION, flip the master
switch located on the right side of the furnace.
The main display indicates the temperature at 3 and the program number at 2.
 To change the program number, use
 To visualize or modify the data in a program:
>
(during this operation, the program number blinks).
 To" lock" the program:
Press a second time.
(The program number stops blinking)
> >
25
PROGRAMIX 25/50/100
key and
>
....etc