Overvoltage Protection; Power Failure - Ugin PROGRAMIX 25 Modo De Empleo

PROGRAMIX 25/50/100
PROTECTIONS
PROGRAM PROTECTION:
 The control station is equipped with a lithium battery to keep the programs stored in the memory
 for approximately five years.
After that period, we recommend that the battery be replaced.

OVERVOLTAGE PROTECTION:

The power supply to a furnace microprocessor must be perfectly filtered.
The PROGRAMIX furnaces are protected against over voltage by a system of active and passive
filters.
Nevertheless. Abnormally high over voltages may cause some interference in the programs.
As a safety precaution, we advise you to record your programs on the table prepared for that
purpose (see the following page)
POWER FLUCTUATION:
Fluctuations in the mains voltage (within a range of ± 20V) have no impact on the operation of the
temperature programmer. However, the heat rise may be lower than the programmed value if the line
drop continues.

POWER FAILURE:

The active cycle is interrupted.
27