3M PELTOR TEP-200 EU Manual Del Usuario página 8

EN
Charging by Battery for the TEP-200 EU/LEP-200 EU/
LEP-200 EU OR
1. To insert the 3 AA batteries into the battery compartment
(Fig. B:1), open the charging case by firmly lifting up the
latch (Fig. B:7).
2. Gently open the battery compartment door inside the
charging case.
3. Insert the batteries while ensuring (+)(-) poles are
aligned according to the diagram on the charging case.
4. Close the battery compartment door.
5. Locate and line up the charging contacts on both the
earpiece (Fig. A:3) and charging receptacle inside the
case (Fig. B:4). Insert the narrow end of the earpiece first
(Fig. D:1), then gently rock and snap it into the receptacle
(Fig. D:2).
6. Repeat for the second earpiece.
Important: Ensure the charging
contacts (Fig. A:3) on the
earpiece are pointed down so
contact is made with the charging
points in the receptacle. Push the
Test/Status button (Fig. B:3) to
verify a good connection is made
between the earpieces and the
charging points in the receptacle.
For the TEP-200 EU/
•
LEP-200 EU, LEP-200 EU OR,
observe the indicator light (Fig.
B:5 and Fig. D:3).
Charging by Micro B USB Port
for the TEP-200 EU/LEP-200 EU/
LEP-200 EU OR/EEP-100 EU/
EEP-100 EU OR
To charge the earpieces, follow
the below.
1. Plug the Micro B end of the
USB cable into the charging case
(Fig. B:6 for TEP-200 EU/LEP-
200 EU/LEP-200 EU OR or Fig.
C:3 for EEP-100 EU/EEP-100 EU
OR) and the opposite end into a
USB power source.
The charger will automatically detect the USB connection and draw power from it instead
of the AA batteries.
Fig. D:3 LIGHT STATUS
Solid Red
Blinking Red
Fast Blinking Red
Solid Yellow
Blinking Yellow
Solid Green
Fig. D:4 LIGHT STATUS
Bright Red
Bright Green
Dim Red
No Light
5
Fig. D:1
Fig. D:2
EARPIECE STATUS
Charging
Not Charging
Temperature Fault
Charging - Low Battery
Not Charging - Low Battery
Charging Complete
EARPIECE STATUS
Charging
Charging Complete
No Earpiece
Temperature Fault or Not
Plugged In