Assembly And Activation; Connecting The Computer; Computer Activation; Start, Control And Signals - Energetics E-102 Manual De Instrucciones

User Manual

Assembly and activation

Connecting the computer

Data cable: .Connect .the .data .cable .coming .from .the .equipment .with .the .
one .coming .from .the .computer .[1] .
Mounting: .Attach .the .computer .to .the .mount .on .the .equipment . . Carefully .
slide .the .insert .sleeve .on .the .back .of .the .computer .over .the .mount .on .the .
centre .post .[2] .
Pay .attention .not .do .damage .the .data .cable .when .sliding .the .computer .
housing .over .the .mount .
Then .you .fasten .the .four .fixing .bolts .[3] .
Hand pulse sensors: .Plug .the .hand .pulse .cable .into .the .connector .on .the .
back .of .the .computer .[4] .
Power supply: . T he .computer .is .powered .with .two .batteries . . Make .certain .
that .the .batteries .are .inserted .correctly .(polarity .+/–) .
1 2 3 3

Computer activation

The .computer .can .be .activated .by .pressing .any .key .or .when .the .user .starts .
to .pedal .

Start, control and signals

The .computer .starts .with .a .short .beep .tone .and .the .standard .settings . . T he .
user .can .start .to .input .his .settings .

Sleep mode

Should .the .E-102 .not .receive .a .signal .for .more .than .4 .minutes .it .changes .into .
the .sleep .mode . . T he .display .turns .dark . . T o .start .again .press .any .key .or .start .
to .pedal .
Input .program .settings .are .deleted .
!
If the computer does not receive a signal
for more then 4 minutes the sleep mode is
activated.
4