Commissioning - SICK WS24-2 Manual De Operación

6

Commissioning

8008782.Z474 | SICK
Subject to change without notice
Table 8: AC/DC relay
H
D
H
D
1 Alignment
Align the sender with the receiver. Select the position so that the red emitted light beam
hits the receiver. Tip: Use white paper or a reflector as an alignment aid. The sender must
have a clear view of the receiver, with no object in the path of the beam [see
must ensure that the optical openings (front screen) of the sensors are completely clear.
Figure 5: Alignment
2 Sensing range
Observe the application conditions: Adjust the distance between the sender and the
receiver according to the corresponding diagram [see
ating reserve).
If several through-beam photoelectric sensors which are installed next to one another are
to be used, we recommend swapping the sender/receiver arrangement at every second
through-beam photoelectric sensor and ensuring that there is sufficient distance between
the through-beam photoelectric sensors. By doing this, mutual interference can be pre‐
vented [see figure 2].
Relay
3
3
4
5
3
4
5
COMMISSIONING
WE24-2R2x0
AC/DC
3
<4 A (250 V AC)
<4 A (24 V DC)
4
<0.11 A (250 V
DC)
5
AC/DC
3
<4 A (250 V AC)
<4 A (24 V DC)
4
<0.11 A (250 V
DC)
5
figure
figure 6] (x = sensing range, y = oper‐
6
5]. You
11