Through-beam photoelectric sensor
1
safety notes
2
Correct use
3
Operating and status indicators
8008782.Z474 | SICK
Subject to change without notice
Operating instructions
Read the operating instructions before commissioning.
■
Connection, mounting, and setting may only be performed by trained specialists.
■
Not a safety component in accordance with the EU Machinery Directive.
■
Power supply: Class 2
■
UL Environmental Rating: Enclosure type 1
When commissioning, protect the device from moisture and contamination.
■
These operating instructions contain information required during the life cycle of
■
the sensor.
The WSE24-2 is an opto-electronic through-beam photoelectric sensor (referred to as
"sensor" in the following) for the optical, non-contact detection of objects, animals, and
persons. A sender (WS) and a receiver (WE) are required for operation. If the product is
used for any other purpose or modified in any way, any warranty claim against SICK AG
shall become void.
(0.39)
1
2
3
27
(1.06)
Figure 1: Dimensional drawing
Alignment sight
1
LED signal strength indicator
2
Center of optical axis
3
M5 threaded mounting hole, 6 mm deep
4
M5 threaded mounting hole, through-hole
5
4
10
14
17.5
(0.55)
(0.69)
5
6
M5
11.8
30
(1.18)
(0.46)
65
(2.56)
5