LiftMaster K71-D1PH Guia De Inicio Rapido página 2

BRAKE PLATE SPACING REQUIREMENTS
Install the brake assembly, using #10 fl atwashers where necessary
(included, see Figure 2), to ensure it is properly seated on the motor and
the belt is straight between the motor and clutch pulley.
AO SMITH / REGAL BELOIT MOTORS (STANDARD LOGIC
5.0 MOTOR FOR BELT DRIVEN OPERATORS)
There are four threaded thru-bolts that protrude on the shaft side of the
motor and are fastened with existing hex nuts #8-32. Add one spacer and
one fl ange nut #8-32 to each thru-bolt (Figure 1).
BALDOR (TEFC) MOTORS (STANDARD LOGIC 5.0 MOTOR
FOR DAMP ENVIRONMENT OPERATORS)
There are four threaded thru-bolts that protrude on the shaft side of the
motor and are fastened with existing hex nuts #10-32. Add one spacer,
one fl atwasher #10 and one fl ange nut #10-32 to each thru-bolt (Figure 2).
Clutch Pulley
Belt
Motor Pulley
FIGURE 1
FIGURE 2
2
Existing Nut
Flange Nut #8-32
Threaded Thru-Bolt
Mounting Plate
Spacer
Flatwasher #10
Existing Nut
Mounting Plate
Threaded Thru-Bolt
Flange Nut #10-32
Spacer