SAFETY RULES
READ AND SAVE THESE INSTRUCTIONS
1.
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker
panel or main fusebox before starting and during
the installation.
2. WARNING: This fixture is intended for installation
in accordance with the National Electrical Code
(NEC) and all local code specifications. If you are
not familiar with code requirements, installation by
a certified electrician is recommended.
3. WARNING: To reduce the risk of fire or electric
shock, use only the control provided with the fan.
4. WARNING: To reduce the risk of fire, electric
shock, or Personal Injury, mount directly to a
structural framing member or to an outlet box
marked "Acceptable for Fan Support of 15.9 kg
(35 lbs) or less." For outlet box mounting, use
mounting screws provided with the outlet box.
5. WARNING: The outlet box and support structure
must be securely mounted and capable of reliably
supporting a minimum of 15.9 kg (35 lbs). Use
only cULus Listed outlet boxes marked "FOR FAN
SUPPORT".
6. WARNING: To operate the reverse function on
this fan, slide the reverse switch to the opposite
position. Do not operate reversing switch while fan
blades stopped before reversing blade direction.
7.
Avoid placing objects in the path of the blades.
8. To avoid personal injury or damage to the fan and
other items, be cautious when working around or
cleaning the fan.
9. Make sure the installation site you choose allows a
minimum clearance of 2.1 m (7 feet) from the blades
to the floor and at least 30 inches from the ends of the
blades to any obstruction.
10. WARNING: make sure the power is disconnected before
cleaning your fan.
11. Do not use water or detergents when cleaning the fan
or fan blades. A dry dust cloth or lightly dampened cloth
will be suitable for most cleaning.
12. After making the electrical connections, spliced
conductors should be turned upward and pushed
carefully up into outlet box. The wires should be spread
apart with the ground wire and white (common) wire to
one side with the black (load) wire to the other side of
the outlet box.
13. Electrical diagrams are for reference only. Light kits
that are not packed with the fan must be ETL Listed
and marked suitable for use with the model fan you are
installing. Switches must be ETL General Use Switches.
Refer to the Instructions packaged with the light kits
and switches for proper assembly.
14. All set screws must be checked, and retightened where
necessary, before installation.
15. Total weight of fan plus any accessories packaged with
the fan: 6.5 kg (14.33 lbs)
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND
THE BLADES DURING ASSEMBLY OR AFTER INSTALLATION.
DO NOT INSERT OBJECTS IN THE PATH OF THE BLADES.
56" Ried
3