Gastrodomus Minitemper Manual Del Usuario página 11

piegh minitemper 12_2016.qxp_piegh minitemper 15/12/16 08:19 Pagina 13
END WORK CYCLE
The work cycle ends once the 3rd stage in the program has been completed. The basin continues to turn; the machine
buzzer sounds. The word end (flashing) appears on the display with the final temperature SP3.
AFTER THE WORK CYCLE
Press the ON/OFF button (see keyboard) to silence the buzzer and stop the basin from rotating.
Press the ON/OFF button again to start the basin turning and keep the temperature constant at the SP3 (3rd stage
level). Press the ON/OFF button to stop.
Note:
You can always check the stage during the work cycle by pressing key P . The display will show the stage for 3 seconds:
e.g. SP2 (with temperature level 2) PA2 (with pause 2). You can interrupt the work cycle by pressing the "start" key.
The cycle is reset while the program type is still that saved and shown on the display. Press the button (04) on the right
of the machine to mix and amalgamate the product better during heating (or when the product is hotter than 35 °C.
SWITCHING THE MACHINE OFF
After using the machine, flip the ON/OFF switch (03) to "O" and then unplug the power cable (07).
AUTOTEST
The "autotest" function lets you check the condition of the various machine components.
The procedure involved:
- hold the "start" key down and press the "ON/OFF switch" (03);
- the word TES appears on the keyboard display.
You can now:
a) – press "I O" (ON/OFF) to check the motor; press again to stop;
b) – press "start" to switch on the lamps; press again to switch off;
c) – press "P" to switch on the fan; press again to switch off.
You need to switch the machine off in order to quit this programming mode.
CHANGING THE BASIN
REMOVAL
Switch the machine off by turning the red "ON/OFF switch" (03) to "O" (on the right of the machine).
Unplug the "male" plug (07) from the mains socket (machine not powered up). Remove the cover (05).
Extract the temperature probe (10) from its seat (11) on the dividing wall (08). Loosen the two threaded knobs (09)
so that the two curved side sections on the dividing wall come away from their columns. Turn the dividing wall (08)
anti-clockwise to separate from the columns. Remove the dividing wall (08). Extract the basin (12).
REPOSITIONING
Make sure that the "male" plug (07) on the power cable is not plugged into the mains socket (machine not powered up).
Make sure that the basin (12) and the dividing wall (08) are clean (we recommend washing with hot water).
Place the basin in the machine by positioning the three pins in the holes on the motor rotation disk.
Add the dividing wall (08), making sure that the two curved side sections fit on the columns.
Tighten the two threaded knobs (09) on the columns to secure the dividing wall.
Introduce the probe (10) in its seat (11) on the side of the dividing wall.
The machine can now be switched on again and programmed for a new work cycle.
10
11
12
MACHINE WITHOUT COVER
09
08 – dividing wall
09 – knurled knob
08
10 – temperature probe
11 – seat for temperature probe
12 – basin
13