LIMIT LDM 40 Manual Del Usuario página 7

Press for Length.
Press again for Width.
Press thirdly for height.
The device calculates and shows the result in the major display area.
Press , clear off the result and measuring again if necessary.
Press again to exit the mode.
5. Pythagorean measurement
A
C
There are four Pythagoras modes in case that user gets hard to reach the target.
A. Calculate the second leg by measuring the hypotenuse and another leg.
Short press three times to enter Pythagoras mode, the hypotenuse of
blinking.
Press , measure the length of hypotenuse (a).
Press , measure the length of one leg (b).
Device calculates the length of another leg (x).
B. Calculate the hypotenuse by measuring the length of two legs.
Shor press four times, when one leg of
Press , measure the length of one leg (a).
Press , measure the length of another leg (b).
Device calculates the length of hypotenuse (x).
C. Press five times till the one side of
Press , measure the length of one side (a).
Press , measure the length of the median line (b).
Press , measure the length of another side (c).
Device calculates the length of the leg in full line (x).
D. Press six times till the hypotenuse of
Press , measure the length of one hypotenuse (a).
Press , measure the length of another hypotenuse (b).
Press , measure the length of one leg (c).
Device calculates the length of the leg in full line (x).
Legs must be shorter than hypotenuse, or there will be "err" shows on screen. In order to
guarantee the accuracy, please make sure all measurements are start from the same point.
6. Addition/subtraction
The device can be used for length addition and subtraction. Press
function once get the length measuring result.
Short press , "+" shows in the major display area, entering cumulation mode. Value of
last measurement and the result of cumulation will be showed on the screen.
B
D
blinking.
blinking on the screen.
blinking on the screen.
GB
to select the
5