Storage; Troubleshooting - Steinbach Poolrunner S63 Manual Original

3. Thoroughly rinse the filter unit with
plain tap water.
4. Rinse the device and the floating cable
after each use with plain tap water
inside and out.
The device is clean.

Storage

1. Thoroughly clean the device (see section "Cleaning").
2. Let all parts dry completely.
3. Then store the device and its accessories in a dry and frost-free place (≥ +5 °C)
without direct sunlight.

Troubleshooting

Fault description
The cable is twisted or tangled. The device turns in the water
The device cannot reach all
spots.
42
15
Cause
during cleaning (this is
normal).
There are obstacles in the
pool.
The cable in the water is too
long.
The nozzle setting is not
suitable.
The cable is too short.
The water circulation of the
pool is switched on.
Remedy
Switch off the device,
disconnect the cable and
untangle it.
Remove the obstacles.
Pull the excess cable length out
of the water. The cable in the
water should only be long
enough so that the device can
reach all spots in the pool.
Change the setting of the
nozzles.
Let a sufficient length of cable
into the pool so that the device
can reach all spots in the pool.
Observe the minimum
distance of the control unit to
the pool.
Switch off the filter system of
the pool.