AirSep FreeStyle Manual De Instrucciones página 204

Caution: When using FreeStyle with the universal power supply in an automobile, boat, or other
motor vehicle, make sure that the vehicle is started and running before turning on and operating the
FreeStyle unit. If the power supply indicator light does not illuminate and requires resetting,
disconnect the power supply from the motor vehicle's DC outlet, restart your vehicle, and then
reconnect your power supply into the DC outlet.
1. Make sure your power supply is securely connected to the FreeStyle inlet, as shown in Figure 14.
2. Connect the proper DC power cord end to the inlet marked ACCESSORY DC IN on the
power supply, as shown in Figure 17.
3. Turn on your motor vehicle.
4. Connect the DC power cord to the motor vehicle's DC outlet, as shown in Figure 18.
5. To operate the POC, press the FreeStyle [1], [2], or [3] setting on the unit's top panel, as
determined by your prescription. To turn the unit off, press the setting associated with the LED
illuminated above it.
AirSep's FAA-approved FreeStyle enables you to use this POC in-flight on most
commercial airlines around the world. Each airline establishes its own policy for FAA-
approved POC use, as well as the requirements for, and the availability of, optionally
allowing you to power your unit onboard the aircraft. Aircraft-equipped passenger power
may include one or more of the following sources: an AC power outlet, a DC power outlet
similar to that typically found in an automobile, or a DC power outlet with a 4-pin
configuration.
If the specific airline on which you are traveling allows you to connect your POC unit at a seat
equipped with a 4-pin DC power configuration, take the following steps:
MN131-1 rev C
Figure 17 Figure 18
EN-22