Technical Parameters - YATO YT-82207 Manual De Instrucciones

TOOL CHARACTERISTICS
The random orbital sander is an ordinary power tool, with class II insulation, designed to sand and smooth wooden surfaces, paint
coatings, and fi ller putties when dry. Thanks to the base disc adapted for attaching sandpaper of diff erent grit sizes, it is possible
to use the tool in a comprehensive manner. The tool is designed for household use only and must not be used professionally, i.e.
in workplaces or for paid work. The correct, reliable, and safe operation of the tool depends on its proper use, therefore:
Read this entire instructions manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
specifi ed in this instructions manual.
EQUIPMENT
The sander is supplied complete and does not require any further assembly. The sander comes with a bag for collecting dust
generated during work.

TECHNICAL PARAMETERS

Parameter
Catalogue No.
Rated voltage
Rated frequency
Rated power
Rated speed
Sanding disc size
Weight
Noise level (without load)
sound pressure
sound power
Vibration level (under load)
Insulation class
Protection rating
Caution! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is
used.
Caution! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of
use (including all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time), must be
specifi ed.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
Avoid contact with earthed surfaces such as pipes, radiators and coolers. Grounding the body increases the risk of electric shock.
Do not expose power tools to contact with atmospheric precipitation or moisture. Water and moisture that gets inside the
power tool increases the risk of electric shock.
Do not overload the power cable. Do not use the power cord to carry, pull or unplug the power plug from the power outlet.
O R I G I N A L
GB
Unit
[V~]
[Hz]
[W]
[min ]
-1
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s ]
2
I N S T R U C T I O N S
Value
YT-82207
220 - 240
50/60
450
4000 - 13000
150
2.4
79.0 ± 3.0
90.0 ± 3.0
12.5 ± 1.5
II
IPX0
11