Technical Data - YATO YT-09740 Manual Original

CHARACTERISTIC OF THE TOOL
Pneumatic eccentric grinder is a tool powered by compressed air stream. By using the grinding agents, which are set directly on
disks, it is possible to grind and polish the surfaces of various type. The device is designed for use in households only and should
not be used professionally i.e. at factories or for a gainful employment. The tool is not intended for continuous operation. The
recommended mode of work is part-time operation during the 5 minutes, and then you should wait 30 minutes to cool the tool.
Correct, reliable and safe operation of tool is dependent on its actual usage, because of that you should:
Prior to the commencement of work with tool you should read all the instructions and keep it.
For any damages and injuries resulting from the improper use of tools, or not complying with safety regulations and the recom-
mendations of this manual, the supplier shall not bear any responsibility. The use of tool, which is unconformable with its designa-
tion, would also cause the loss of user's rights for guarantee, and also as result of non-compliance with the contract.
EQUIPMENT
The grinder is equipped with connector to connect it to the pneumatic system. The grinder is equipped with disk of diameter of 150
m. Any additional tools are not required for it assembly.

TECHNICAL DATA

Parameter
Catalog number
Weight
The diameter of air connection (PT)
The diameter of air supply hose (internal)
Revs
The diameter of tool handle
Diameter of the disk
Maximum operation pressure
Required air flow (at 6.2 bar)
Acustic pressure (EN ISO 15744)
Acustic power (EN ISO 15744)
Vibrations (ISO 28927-3)
GENERAL SAFETY CONDITIONS
WARNING! During the tool operation you should always adhere to the fundamental principles of security including the following
guidelines, in order to reduce the risk of fire, electric shock, and avoid injuries.
Before proceeding to the use of this tool you should read the whole instruction and keep it.
ATTENTION! Read all the following guidelines. Failure to comply with them may lead to electric shock, fire, or damage to the
body. The concept of a "pneumatic tool", which is used in the instructions refers to all tools driven by compressed air stream under
proper pressure.
FOLLOW THE GUIDELINES BELOW
General safety rules
Prior to installation, operation, repair, maintenance and modification of accessories or, in the case of work near pneumatic tool,
because of the many risks, you should read and understand the safety instructions. Lack of implementation of these activities
can result in serious injury. Installation, regulation and assembly of pneumatic tools can be performed only by qualified and
trained personnel. Do not modify the pneumatic tool. Modifications may reduce its efficiency and safety level and increase the
risk for the tool operator. Do not throw away the safety instructions, they must be passed to the tool operator. Do not use the
pneumatic tool, if it is damaged. The tool should be periodically inspected for visibility of data, which is required by the standard
ISO 11148. The employer / user should contact the manufacturer in order to exchange plate every time when it is necessary.
The risks associated with entanglement
The risks associated with entanglement may cause choking, scalping and / or injury when loose clothing, jewelry, hair or gloves
are not kept away from tool and accessories.
O R I G I N A L
10
GB
Unit
[kg]
[mm]
[" / mm]
[min -1 ]
[mm]
[mm]
[MPa]
[l/min]
[dB(A)]
[dB(A)]
[m/s 2 ]
I N S T R U C T I O N S
Value
YT-09740
0.95
1/4 / 6.3
3/8 / 10
10 500
M8
150
0.63
84
90 ± 3
101 ± 3
4.4 ± 1.5