Time Setup; Brightness; Auto Dim; Approved Mode - OHAUS PJX Serie Manual De Instrucciones

PJX Series Balance

5.3.8 Time Setup

Set the current time in the desired time format.
To set the current time, press No or Back to increase or decrease the
value.

5.3.9 Brightness

Set the brightness of the display.
Medium
High
Low

5.3.10 Auto Dim

Set whether the balance automatically turns off the display backlight of
the display.
Off = disabled.
10 minutes = become dim if there is no motion in the display for 10 minutes.
20 minutes = become dim if there is no motion in the display for 20 minutes.
30 minutes = become dim if there is no motion in the display for 30 minutes.
10 mMin
10 min

5.3.11 Approved Mode

Use this menu to set the Legal for Trade status.
OFF = standard operation.
ON = operation complies with Legal Metrology
Note: When Approved Mode is set to On, the menu settings are affected as follows:
Calibration Menu:
For InCal models, only Internal Calibration is available. All other functions are hidden.
For ExCal models, the entire Calibration menu is hidden.
bright
Brightness
HIGH
High
20 mMin
20 min
regulations.
EN-25
timME
08.00.00
mMEd
Medium
mMEd
Low
Aut.dimM
30 mMin
30 min
LFt