Using The Stop With Type 4X-Cnz45; Mounting The Handle On Type 9F-Cnw100Epal - Prebena 3X-CNW50 Manual De Instrucciones Original

Using the stop with type 4X-CNZ45

Fastener driving tool 4X-CNZ45 is equipped with an adjustable stop.
The stop is on the bottom of the magazine. A centimeter scale (3)
and an inch scale (2) are available for adjusting.

To adjust the stop (1) press the stop locking mechanism (4)
in the direction of the arrow.
The stop engages for every centimeter and inch increment.

Push the stop to the desired position.

Release the locking mechanism.
The stop is adjusted.

Mounting the handle on type 9F-CNW100EPAL

Fastener driving tool 9F-CNW100EPAL must be used with both hands.
Because of this it is equipped with an additional handle.

To mount the handle (1), place it on the thread (2) on the housing
of the fastener driving tool.

Screw the handle clockwise tightly onto the thread.
Preparation of the fastener driving tool
25