Adjusting type 7F-CNW90
The insertion depth of type 7F-CNW90 is determined by the position
of the lower safety bar. The higher you mount the lower safety bar,
the deeper the insertion depth.
To change the insertion depth, loosen the cylinder screw (1).
Move the lower safety bar (2) vertically along the safety bar (3)
to the desired position.
Tighten the cylinder screw firmly.
Adjusting type 8XR-CNW90
For fastener driving tool 8XR-CNW90, you can adjust the insertion depth
of the coil nail by adjusting the setting wheel and changing the operating
pressure of the compressor.
The following symbol appears on the housing
of the fastener driving tool:
Operating the fastener driving tool
This symbol shows
the direction the setting
wheel must point in to reduce
or increase the insertion depth.
To change the insertion depth,
turn the setting wheel (1) in the
desired direction.
29