Technical Data - Ottobock 6Y200-VarosLiner Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 24
Cleaning the inside
1) Turn the liner inside out.
2) Hand wash the liner in warm water (30 °C) using neutral detergent (e.g.  Ottobock 453H10=1
Derma Clean).
3) Thoroughly rinse the liner with clear water until all detergent residues have been removed.
4) Turn the liner again so the outer side/textile material is on the outside.
5) Put a hand towel into the liner and leave the liner to dry lying flat on a drying rack. Alternat­
ively, use a drying stand (TT: 5Y100=1 TF: 5Y100=2).
NOTICE! Liner with textile cover: To avoid damaging the liner, dry it with the textile
material on the outside.
Cleaning the outside
► Clean the outside of the liner approximately every 1 or 2 weeks. The procedure is the same as
for the inside of the liner.
Cleaning the magnetic cap
► Clean the cap with a dry or moist cloth.
7 Shipment
There must not be any significant magnetic effect on the outside of the packaging when the
product is shipped. The provisions of the shipper must be observed.
1) Keep the original packaging in case the product needs to be shipped.
2) Tip: Tilt the packaging at a 45° angle and place a paper clip on it. If the paper clip slides off,
no magnetic effect is present.

8 Technical data

Liners
Reference number
Length (not shortened, outside dimension) [mm]
Weight [g]
Circumference (inside, at the rim of the liner) [mm]
Circumference (inside, 50 mm from the bottom of the liner) [mm]
Coupling force to 5A60=* Varos [N]
Measuring point
Inside, close to the magnetic cap
Inside, 10 cm from the magnetic cap
Outside, close to the magnetic cap
Outside, 10 cm from the magnetic cap
Measuring point
Inside, close to the magnetic cap
Inside, 10 cm from the magnetic cap
Exterior of prosthetic socket, close to the distal con­
nection
Exterior of prosthetic socket, 10 cm from the distal
connection
12
Liner without prosthetic socket
Magnetic flux density [mT]
Liner with prosthetic socket attached
Magnetic flux density [mT]
Size M
6Y200=M-1
450
650
440
330
150 (typical)
<3
<0.05
<400
<0.2
<15
<0.05
<10
<0.05
6Y200=M-2
450
680
470
360

Publicidad

Tabla de contenido
loading

Tabla de contenido