Rear Panel; Sockets Panel; Accessories; General - Selco Genesis 284 PSR Instrucciones De Uso

E53 External flow switch alarm
Guard limits code
E54 Current level exceeded (Alarm)
E62 Current level exceeded (Warning)
E55 Current level exceeded (Alarm)
E63 Current level exceeded (Warning)
E56 Voltage level exceeded (Alarm)
E64 Voltage level exceeded (Warning)
E57 Voltage level exceeded (Alarm)
E65 Voltage level exceeded (Warning)
E58 Gas flow level exceeded
E66 Gas flow level exceeded
E59 Gas flow level exceeded
E67 Gas flow level exceeded
E60 Speed limit exceeded
E68 Speed limit exceeded
E61 Speed limit exceeded
E69 Speed limit exceeded
All manuals and user guides at all-guides.com
(Alarm)
(Warning)
(Alarm)
(Warning)
(Alarm)
(Warning)
(Alarm)
(Warning)

3.15 Rear panel

1 Power supply cable
Connects the system to the mains.
2 Gas fitting
3 Signal cable input (WF)
4 Signal cable input RC-RI (CAN BUS)
5 Off/On switch
Turns on the electric power to the welder.
It has two positions, "O" off, and "I" on.

3.16 Sockets panel

1 Negative power socket
For connection of earth cable in electrode welding or of
torch in TIG.
2 Positive power socket
For connection of electrode torch in MMA or earth
cable in TIG.
3 Torch fitting

4 ACCESSORIES

4.1 General

Operation of the remote control is activated when connected
to the Selco power sources. This connection can be made also
with the system power on.
With the RC control connected, the power source control panel
stays enabled to perform any modification. The modifications
on the power source control panel are also shown on the RC
control and vice versa.
43