Tabla de contenido
Publicidad
By pressing the „Details" key F3 the addresses of the modules can be checked.
Example:
Internal Modules
>01 FRP with FBC
02 Remote LCD Panel
03 Remote LCD Panel
04 FRP
05 -
06 -
Cancel
By letters "A" und "B" will be displayed, on which channel of the redundant RS485 bus each
device has been connected.
Addresses of the RS485 devices correctly set?
Wiring of the RS485 devices correct?
Addressable detectors/modules
During the initialisation permanently a counter will be displayed which is counting the total number of
all detectors and modules. After scanning the loop devices, a list of these devices will be displayed.
This list will be visible each time the number of recognised detectors/modules has changed after
scanning the loops. Therefore after first time initialisation process all new recognised
detectors/modules will be listed.
Example:
Detector configuration
Seg.
|Add| Error
>01 o 1|001|
01 o 1|002|
01 o 1|003|
01 o 1|004|
01 o 1|005|
continue
all ok
In line 1 the number of all recognised detectors and modules will be displayed. In the table for each
device will be displayed:
- Segment, where the device is connected to
- Symbol for loop "o" or spur wiring "-"
- number of loop/spur
- configured device address
- error code ("new" in this example)
- programmed zone and detector number
By pressing the "ok" key each single detector can be stored in the FCP programming, by pressing "all
ok" all connected devices will be stored in the FCP flash memory simultaneously.
NSC Sicherheitstechnik GmbH
Eckendorfer Str. 125 c
33609 Bielefeld
0001/0265
|
Zone
|Detect
new
|
0000
| 000
new
|
0000
| 000
new
|
0000
| 000
new
|
0000
| 000
new
|
0000
| 000
64/71
01/63
A
B
A
A
A
B
Details
ok
o.k. fault
o.k. fault
10.10.2012
Manual Solution F1- Español
Version S040A06.03
Publicidad
Tabla de contenido
