Configurar Salidas De Energia; Configuracion Del Sistema De Control De Incendios - NSC Sicherheitstechnik Solution F1 Manual Del Usuario

Configure power outputs
Load resistance
No.: ( old) Norm OC-Tol. Th.OC
1 : (0983) 0983 + 120 = 1103 , 0727 Ohm
2 : (0977) 0977 + 120 = 1097 , 0724 Ohm
3 : (0964) 0964 + 120 = 1084 , 0717 Ohm
Cancel Calib.
The thresholds depend on the load resistance of the connected device inclusive the line resistance.
This total resistance can be ascertained automatically for each power output individually by pressing
"calib." F3. The software then calculates the thresholds for open circuit and short circuit. The
resistance can also be measured with a multimeter and typed in directly using the keyboard.
Configuration of the fire control system
The configuration of the fire control system is very comprehensive and is mainly dependent of the
largeness of installation. The details have to be specified in the planning documents. The
following checklist describes the individual steps of the programming of the fire control panel:.
Programming
Zones
Detector configuration
- sensitivity
- mode of multi sensors
- time program
- pre alarm
- alarm delay
Detector texts
Programming
Zone parameters
- cross detection
- internal alarm zone
- fault zone
- manual call point (only for
conventional detectors or
modules)
Cross zoning
Timer programs
- for delay
- for detector sensitivity
Delay
Power outputs
- key deposit box
- sounders/flashlights
- transmission device
Controlling of relays, outputs or
output modules
Loop sounders
Controlling by special keys
System parameters
Holidays
NSC Sicherheitstechnik GmbH
Eckendorfer Str. 125 c
33609 Bielefeld
Tolerance
Th.SC
save
Menu topic
Alarmorganisation
Alarmorganisation
by PC software
Menu topic
Alarmorganisation
Alarmorganisation
Alarmorganisation
Alarmorganisation
Autom. controlling
Autom. controlling
Autom. controlling
Configuration
Configuration
Configuration
66/71
 ok.
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
 ok  not used
10.10.2012
Manual Solution F1- Español
Version S040A06.03