CAMPAGNOLO 11 SPEED Manual Del Usuario página 13

5. CABLE ASSEMBLING AND ADJUSTING
• Carry out this adjustment with the
chain on the smallest freewheel sprocket
and with the Ergopower control button
zero-ed (Fig. 7).
• Turn the screw (B - Fig. 8) until perfect
alignment is obtained between the cen-
treline of the top roller and the axis of
the first sprocket (Fig. 9).
• Check the length and, if necessary, shor-
ten the casing. Take care to cut it straight
across without altering the configuration of the casing and without damaging
the cable in any way. If the cable is damaged, please replace it before riding
your bicycle. If the casing is too short, rear derailleur operation will be affected.
8
B
24
7
9
ENGLISH
Cables and casings do not
require lubrication since they
are supplied already lubrica-
ted.
• Pass the cable through the
adjustment screw (C - Fig. 10)
and insert the end of the casing;
then pass the cable underneath
the plate (E - Fig. 10) and clamp it
by tightening the Allen screw (D
- Fig. 10) at a tightening torque
of 6 N.m - 4.4 lb.ft. Cut the excess
cable at about two cm. from the
clamping screw and protect the
end with a cable cap.
• Make sure that the screw (G
- Fig. 12) is correctly adjusted: by
operating the gear lever with the
chain on the largest sprocket, the
inner plate of the derailleur cage
must NOT come into contact
with the spokes.
• Position the chain on the 5° sprocket
counting from the smallest.
• Turn the cable tension adjuster (F - Fig.
11) until perfect alignment is obtained
between the centreline of the top roller
and the centreline of the fourth sprocket.
• If centering between the centrelines of
the roller and the fourth sprocket is not
correct, turn the adjuster (F - Fig. 11) coun-
terclockwise to shift the rear derailleur
inwards. Turn clockwise to shift the rear
derailleur outwards.
ENGLISH
10
E
C
D
5 mmAllen wrench
6 N.m - 4,4 lb.ft
CLOSE
11
F
25