Error Messages - CAMPAGNOLA COBRA PRO Manual De Uso Y Mantenimiento

Clamping:
Check the clamping status of the blade: carried out on a numerical scale from 0 to 10.
Clamping of the blade is determined by the type of blade used.
A value 0/2 means the blade is too loose, while 9/10 it is too tight.
WARNING!
Clamping can change considerably depending on the conditions of use of the blades, which must always be
sharpened, clean and lubricated.
Procedure:
Press the trigger and wait for the blade to close.
Release the trigger and wait for the blade to open.
Assess the result and tighten or loosen, to obtain the appropriate value of the blade used.
Repeat the operation to achieve correct clamping.

Error messages

E1 = No shear detected.
E2 = OVERCURRENT Fault detected on the motor.
E3 = Incompatible shear detected.
E4 = Cord cut: the cord has been cut inadvertently.
A1 = MAX TEMP: high external temperature of the motor.
Wait for the temperature to drop before resuming work.
It normally occurs when the operator performs consecutive cuts very quickly.
A2 = OVERLOAD: high internal temperature of the motor.
Wait for the temperature to drop before resuming work.
It usually occurs when the operator attempts consecutive cuts on large branches.
WARNING!
Do not exert excessive pressure on the trigger (15). This does not increase cutting force.
WARNING!
Always use adequate clothing as called for by the job. Wear a protective helmet and make sure that your clothes
are fitting to the body. Avoid wearing neckties, necklaces, belts or long hair
tween the moving parts.
When holding the tool in your hand, perform the following operations in order:
a) Carefully insert a branch between the blades of the shear and press the trigger (15) of the tool to prune the branch.
b) After having made the cut, release the trigger (15). To make further cuts, repeat the operation described in point a)..
WARNING!
Remember that the charge value of the battery pack is indicative. We recommend recharging the battery at the
end of each work day. Even if still partially charged.
Pag. 32
COBRA PRO: clamping must be between 6 and 7.
COBRA PRO VIGNA (Optional blade): clamping must be between 5 and 6.
PONY PRO: clamping must be between 4 and 5.
not tied as they can be caught be-
Use and Maintenance Manual – Original
Instructions Rev.: 00, Date 10/10/2018