CLAS OH 9040 Guia Del Usuario página 12

OH 9040
AIR HYDRAULIC JACK 20/40T
- Install a lter dehumidi er-lubricator unit in the compressed air system.
- If you want to lubricate the compressed air circuit use exclusively:
AGIP OSO 100; MOBIL DTE 27; ESSO TERESSO 100; SHELL TELLUS 100; BP ENERGOL HP 100
ACCESSORIES
The jack is supplied with two extensions or height adapters (120 mm the long extension, 70 mm the short
extension), a circular tooth plate (10 mm plate) and an extension holder.
Never use more than two extensions! The manufacturer is not liable for any damage
resulting as a consequence of disregard for the above indications and the warranty
conditions are invalidated thereof!
SCRAPPING AND DISPOSAL
- The lubricants must be disposed of in compliance with the anti-pollution laws in force.
- Scrapping the jack and its component parts must be carried out by the user in accordance with current laws.
USE
Expressly observe the safety rules already described in this manual.
1.Position the jack under the supports as described in the manual of
the vehicle. the manufacturing company is not responsible for any
break or damage to the lifted vehicle or to persons or property due to
an incorrect use of the jack.
2. The handle positioning lever (A) is on the left in relation to the
worker; by moving it upwards the stopping system is released so the
worker can then choose one of the three possible handle positions.
DWG. 13
3. When control (B) is in the perfectly central position, the jack is in
the idle status.
4. By turning control B, located near the handle, towards the right in
relation to the worker, the jack lifts the load.
5. By turning control B, located near the handle, towards the left in relation to the worker, the jack lowers the load.
DWG. 13
6. After lifting the load, it is absolutely essential to rest it on the support stands before doing any work under it.
REMEMBER THAT THE JACK IS A LIFTING DEVICE AND NOT A SUPPORTING DEVICE!!
- The operator's employer will have to provide the necessary training and furnish the necessary information about
the pumping and shifting forces.